|
1. First Clean window with Windex. |
|
2. Place a piece of masking tape over the entire middle of the decal with a inch or more hanging over each edge. |
|
3. Place decal on surface and tape it down.
|
 |
| 4. This tape acts as a temporary holder so you can get your decal right where you want it. |
| 5. After measuring everything (if necessary), make sure your decal is ready and peel the decal from the backing with the pre mask still attached, like in the picture below. |
 |
| 6. With the decal and front pre mask detached from backing, rip the backing off under the pre mask, right in the middle where the long piece of tape is holding the whole decal to the surface. |
| 7. Then from the middle where your long piece of tape is, take a squeegee or your drivers license (credit card works too)and push decal down on surface in a nice smooth motion. Remember to hold end of pre mask till you reach that part with the squeegee |
 |
| 8. Once you have the one side applied to the surface do the same for the other half that still has the backing still attached. Pull the rest of the backing off and slowly from the middle push decal to the surface till you reach the end. |
| 9. Then run your squeegee over the decal a few time to make sure its evenly applied to the surface so when you pull the pre mask off the decal does not lift off as well. |
|
10. Then from one side slowly pull the pre mask off. Start by peeling off a corner and once you have enough pre mask, fold it over onto itself and pull back reveling the decal that was applied to the surface. |
 |
| 11. After pulling the pre mask off completely, walla, you have your decal nicely applied to the surface. If you should have any bubbles you may take a pin and put a small hole into the bubble and push the air out with your finger. Letting the decal sit in the sun day after day will make any real small bubbles disappear on their own. |
 |